|
Up-Flow Cartridge Filters...
A design so superior it's patented
Harmsco® Up-Flow Cartridge
Filters outperform conventional filter designs because the outlet
is located above the inlet to eliminate air entrapment during
operation. With Up-Flow Cartridge Filters, liquid enters the vessel
through the inlet, located at the bottom of the filter. As the
liquid travels upward, it flows through the filter media, past
the top seal, separating the dirty and clean water chambers, and
down the standpipe as it exits the filter. Because the top of
the standpipe is located above the top seal, air is self-purged
from the filter to eliminate vents and improve filtration efficiency.
Additional features and benefits are described below.
|
|
Rugged
stainless steel construction
Harmsco Up-Flow Cartridge Filters are made of low carbon 304
stainless steel for durability and long equipment life.
|
|
Individual
studs for safe, secure lid closure
We have the safest lid in the business with individual studs
for optimum security. No v clamps with on one bolt to secure
lids.
|
Electro-polished
for increased resistance to corrosion
All stainless steel components are electroplated fro a superior
finish and increased durability. |
|
Easy
cartridge installation, removal and service
Our 7, 14,16,21 and 24 cartridge models have all cartridges arranged
in a single "cartridge cluster" for easy installation,
removal and service. This makes maintenance a snap! |
Pressure
rated and hydrostatically tested
All Cartridge Filters are pressure rated to 150 psi (10 bar) and
hydrostatically tested. |
|
Wing
nuts
Wing nuts are used so no tools are required. Finger tight is generally
sufficient. Hex nuts are recommended with 75 foot lbs. Of torque
above 100 psi. |
Two
Up-Flow Cartridge Filter Styles
We manufacture a complete line of stainless steel
filter housings using the two cartridge filter designs shown below.
|
Chemical
Resistant Coating
Harmsco Up-Flow Cartridge Filters are available with DYKOR coating,
a high performance material like TEFLON®, used to provide
increased resistance to chemicals, abrasion and the environment.
Fluoropolymer coating is applied to all stainless steel surfaces
(inside and out) DYKOR is far more resistant than 316 stainless
steel.
|
 |
 |
 |
 |
|
Cartridge
Cluster Filters
All Up-Flow
Cartridge Filters in our 7, 14, 16, 21
and 24 models are arranged in a single "cartridge cluster",
so all cartridge filters are removed at one time.
|
|
|
High
capacity Models
With these models, Up-Flow
Cartridge Filters are installed on lifting
rods so a single stack of cartridges are removed on time for
convenience.
|
|
